YASKAWA Sigma-7 Series Product Manual page 57

3.4 Position Correction Table Settings
3.4.3 Setting Method with the SigmaWin+
5.
To write only the parts of the Position Correction Table that were edited to the SERVO-
PACK, click Edited Parameters in the Write to Servo Group.
To write the entire Position Correction Table to the SERVOPACK, click All Parameters in
the Write to Servo Group.
Information
6.
Click the OK Button.
The created Position Correction Table was written to the volatile memory in the SERVOPACK.
The background of the edited parameter cell will change to orange.
3-10
Parameter will be used in the dialog box, but parameters are not written to the SERVO-
PACK.
The Position Correction Table is written to the SERVOPACK.