YASKAWA Sigma-7 Series Product Manual page 13

 Notation Used in this Manual
 Notation for Reverse Signals
The names of reverse signals (i.e., ones that are valid when low) are written with a forward slash (/)
before the signal abbreviation.
Notation Example
BK is written as /BK.
 Notation for Parameters
The notation depends on whether the parameter requires a numeric setting (parameter for numeric
setting) or requires the selection of a function (parameter for selecting functions).
•
Parameters for Numeric Settings
Parameter number
peed Loop Gain
Pn100
etting Range
10 to 20,000
If All Axe i given
here, the parameter
applie to both axe A
and B.
If you change the
etting, the new etting
will be applied to both
axe .
Thi i the etting range for the parameter.
•
Parameters for Selecting Functions
Parameter number
Parameter
n.
(default etting)
Pn00F
All Axe
n.
The notation "n.
Each indicate the etting for one digit.
The notation hown here mean that the fir t digit from the right i
If All Axe i given here, the parameter applie to both axe A and B.
If you change the etting, the new etting will be applied to both axe .
Notation Example
Notation Example for Pn002
n . 0 0 0 0
Notation
Pn002 =
n.
Pn002 =
n.
Pn002 =
n. X
Pn002 =
n.X
The control method for which the parameter apply are given.
peed : peed control
etting Unit
0.1 Hz
Thi i the minimum
Thi i the
unit ( etting increment)
parameter etting
that you can et for
before hipment.
the parameter.
0
Do not detect preventative maintenance warning .
1
Detect preventative maintenance warning .
" indicate a parameter for electing function .
Digit Notation
Meaning
Indicate the fir t digit from
the right in Pn002.
X
Indicate the econd digit
X from the right in Pn002.
Indicate the third digit from
the right in Pn002.
Indicate the fourth digit from
the right in Pn002.
Po ition : Po ition control
Default etting When Enabled
400 Immediately
Thi i when any
change made to the
parameter will
become effective.
Meaning
Thi column explain the
election for the function.
et to 1.
Numeric Value Notation
Notation
Pn002 =
Indicate that the fir t digit from
n. 1
the right in Pn002 i
Pn002 =
Indicate that the econd digit from
n. 1 the right in Pn002 i
Pn002 =
Indicate that the third digit from
n. 1 the right in Pn002 i
Pn002 =
Indicate that the fourth digit from
n.1 the right in Pn002 i
Torque : Torque control
Po ition
peed
Cla ification
Tuning
Thi i the parameter
cla ification.
When Enabled Cla ification
After re tart etup
Meaning
et to 1.
et to 1.
et to 1.
et to 1.
xiii