Displaying And Debugging Mpls Basic Capability; Displaying And Debugging Mpls - H3C S9500 Series Operation Manual

Operation Manual – MPLS
H3C S9500 Series Routing Switches
Table 2-15 Configure LDP authentication mode (between every two routers)
Configure LDP authentication Mode
Remove LDP authentication

2.4 Displaying and Debugging MPLS Basic Capability

2.4.1 Displaying and Debugging MPLS

I. Displaying static LSPs
After accomplishing the configuration tasks mentioned previously, you can execute the
display command in any view to view the running state of a single or all the static LSPs
and thus to evaluate the effect of the configurations.
Table 2-16 Display the static LSP information
Display the static LSP information
II. Displaying the MPLS statistics information or LSP information of all ports or a
single VLAN interface
After finishing the configurations above, execute the display command in any view to
view the MPLS statistics information or LSP information of all ports or a single VLAN
interface. You can verify the effect of the configuration by checking the information on
display.
Table 2-17 Display statistics information of static LSP
Displaying
information or LSP information of all
ports or a single VLAN interface
III. Displaying MPLS-enabled interfaces
After accomplishing the configuration tasks mentioned previously, you can execute the
display command in any view to view the information related to the MPLS-enabled
interfaces and thus to evaluate the effect of the configurations.
Operation
Operation
Operation
the MPLS statistics
2-9
Chapter 2 MPLS Basic Capability Configuration
Command
mpls ldp password [ cipher | simple ]
password
undo mpls ldp password
Command
display mpls static-lsp [ include text |
verbose ]
Command
display mpls statistics
{ Vlan-interface | all } | lsp { lsp-Index | all |
lsp-name }
{ interface