H3C S9500 Series Operation Manual page 311

Operation Manual – Routing Protocol
H3C S9500 Series Routing Switches
higher than the timer command that is used to configure timers for the whole BGP
peers.
Perform the following configuration in BGP view.
Table 6-9 Configure timer of a peer (group)
Configure keep-alive message interval
and hold timer of a peer (group)
Restore the default value of keep-alive
message interval and hold timer of a
peer (group)
By default, the Keep-alive message is sent every 60 seconds and the value of the hold
timer is 180 seconds.
IX. Configuring the interval at which route update messages are sent by a peer
group
Table 6-10 Configure the interval at which route update messages are sent by a peer
group
Configure the route update message
interval of a peer group
Restore
message interval of a peer group
By default, the intervals at which route update messages are sent by an IBGP and
EBGP peer group are 5 seconds and 30 seconds respectively
6.2.3 Configuring application features of a BGP peer (group)
I. Configuring to permit connections with EBGP peer groups on indirectly
connected networks
Generally, EBGP peers must be connected physically. Otherwise the command below
can be used to perform the configuration to make them communicate with each other
normally.
Perform the following configuration in BGP view.
Operation
Operation
the default route
peer { group-name | peer-address }
timer keep-alive
hold holdtime-interval}
undo peer
peer-address } timer
peer
route-update-interval seconds
update undo
route-update-interval
6-9
Chapter 6 BGP Configuration
Command
keepalive-interval
{ group-name
Command
group-name
peer group-name
|