Saving Configuration Information About Connected Switches; Setting The State And Aliases Of An Ethernet Switch - H3C S9500 Series Operation Manual

Operation Manual – Integrated Management
H3C S9500 Series Routing Switches

1.2.3 Saving Configuration Information about Connected Switches

You can save configuration information about the managed switches to the
management device.
Perform the following configuration in HGMP view.
Table 1-7 Save configuration information about management switches
Save the configuration information of a specified Ethernet
switch to the memory of the management device.
Save the configuration information of a specified Ethernet
switch to the flash memory.
Configuration information about a specified Ethernet switch that is saved to the
memory of the management device using the save lswconfig command gets lost after
you reboot the management device.
The backup lswconfig command saves the configuration information the save
lswconfig command retrieves to the flash memory. As data saved in the flash memory
does not get lost even the management device reboots, so, with its configuration
information saved in the flash memory, you can quickly restore the operating state of an
Ethernet switch using its configuration information after the Ethernet switch resets.
# Save the configuration information about the Ethernet switch directly connected to
the 1/1/20-/ port to the memory.
[H3C-hgmp] save lswconfig 1/1/20-/
Waiting........
# Write the configuration information saved in the memory to the flash memory.
[H3C-hgmp] backup lsw
Writing lanswitch configuration to flash......

1.2.4 Setting the State and Aliases of an Ethernet Switch

Contrary to the fact that HGMP identifies Ethernet switches using their position
parameters; it is infeasible for users to locate a managed Ethernet switch by its position
parameter. An intuitive alternative is, to set aliases for Ethernet switches using the set
lswname command.
In addition, you can set the state of an Ethernet switch to be active or inactive through
the management device.
Perform the following configuration in HGMP view.
Operation
1-6
Chapter 1 HGMP V1 Configuration
Command
save lswconfig
lanswitch-loc
backup lswconfig