Configuring Vpls Characteristics - H3C S9500 Series Operation Manual

Operation Manual – NAT-URPF-VPLS
H3C S9500 Series Routing Switches
Remove packet redirection
Note:
After you configure packet redirection, the ports of the public network add to the VALN
(specified join-vlan). After you remove packet redirection configuration, the ports exit
from the corresponding VLAN.

3.5.12 Configuring VPLS Characteristics

I. Configuring VPN rate limitation
Use the bandwidth command to configure the VPN rate limitation in the range of 64
kbps to 4,194,303 kbps with the increment of 64. After the configuration, the system
automatically takes the biggest number that can be exactly divided by 64 and is no
more than the setting number as the rate limitation. For example, if you specify the VPN
rate limitation to be 200, then the actual is 192, three times of 64. The actually
supported rate limitation ranges from 64 kbps to 2,097,152 kbps (included), and if the
value you set is above 2,097,152 kbps, no rate limitation is performed. In the instance,
the part of traffic beyond this bandwidth restriction is discarded by the system.
Perform the following configuration in VSI-LDP view.
Table 3-16 Configure VPN rate limitation
Configure VPN rate limitation
By default, the VPN rate limitation is 102,400 kbps.
II. Configuring VPN broadcast suppression percentage
Use the broadcast-restrain command to configure the VPN broadcast suppression
percentage, which is in the range of 0 to 100. You cannot set the percentage to 0. In the
VSI, the part of broadcast traffic (including broadcast, multicast, and unknown unicast)
beyond the suppression percentage is discarded.
Perform the following configuration in VSI-LDP view.
Operation
Operation
3-14
Chapter 3 VPLS Configuration
Command
undo traffic-redirect inbound link-group
acl-number [ rule rule ]
Command
bandwidth vpn-speed