Operation Manual – Multicast Protocol
H3C S9500 Series Routing Switches
Table 6-6 Configuring the maximum number of PIM neighbor on an interface
Configure the maximum number of PIM neighbor on an
interface
Restore the limit of PIN neighbor to the default value
By default, the PIM neighbors on the interface are limited to 128.
If the number of PIM neighbors of an interface has exceeded the configured value by
the time of configuration, the existing PIM neighbors will not be deleted.
6.2.8 Clearing PIM Routing Table Entries
Perform the following configuration in user view.
Table 6-7 Clearing multicast route entries from PIM routing table
Operation
Clear
route entries from
PIM routing table
6.2.9 Clearing PIM Neighbors
Perform the following configuration in user view.
Table 6-8 Resetting PIM neighbor
Operation
Clear
neighbors
6.3 Displaying and Debugging PIM-DM
After the above configuration, execute display command in any view to display the
running of PIM-DM configuration, and to verify the effect of the configuration.
Execute debugging command in user view for the debugging of PIM-DM.
Operation
reset pim routing-table { all | { group-address [ mask
multicast
{ group-mask | group-mask-length } ] | source-address [ mask
{ source-mask | source-mask-length } ] | { incoming-interface
interface-type interface-number | null } } * }
PIM
reset pim neighbor { all | { neighbor-address | interface
interface-type interface-number } * }
Chapter 6 PIM-DM Configuration
Command
Command
6-6
Command
pim neighbor-limit limit
pim neighbor-limit