Configuring Acl For Snmp Users; Configuration Prerequisites - H3C S9500 Series Operation Manual

Routing switches

Hide thumbs Also See for S9500 Series:

Table of Contents

Operation Manual – QoS/ACL

H3C S9500 Series Routing Switches

II. Network diagram

Figure 3-2 Network diagram for source IP control over Telnet users

III. Configuration procedure

# Define a basic ACL.

<H3C>system-view

System View: return to User View with Ctrl+Z.

[H3C] acl number 2000 match-order config

# Define rules.

[H3C-acl-basic-2000] rule 1 permit source 10.110.100.52 0

[H3C-acl-basic-2000] rule 2 permit source 10.110.100.46 0

[H3C-acl-basic-2000] rule 3 deny source any

[H3C-acl-basic-2000] quit

# Enter user interface view.

[H3C] user-interface vty 0 4

# Apply the ACL.

[H3C-user-interface-vty0-4] acl 2000 inbound

3.3 Configuring ACL for SNMP Users

S9500 series switches can be managed remotely through network management

software (NMS). Administrators can use SNMP to access an S9500 series switch.

Proper ACL configuration can prevent unauthorized network management users from

logging onto the switch.

You have correctly configured log into the switch using SNMP.

Chapter 3 Logon User ACL Control Configuration

Table of Contents

S9505 S9508 S9512