H3C S9500 Series Operation Manual page 712

Operation Manual – STP
H3C S9500 Series Routing Switches
Table 1-23 Configure the port (not) to connect with the point-to-point link
Configure
point-to-point link.
Configure the port not to connect with the
point-to-point link.
Configure MSTP to automatically detect if the port
is directly connected with the point-to-point link.
Configure MSTP to automatically detect if the port
is directly connected with the point-to-point link, as
defaulted.
II. Configuration in Ethernet port view
Perform the following configuration in Ethernet port view.
Table 1-24 Configure the port (not) to connect with the point-to-point link
Configure the port to connect with the point-to-point link.
Configure the port not to connect with the point-to-point link.
Configure MSTP to automatically detect if the port is directly
connected with the point-to-point link.
Configure MSTP to automatically detect if the port is directly
connected with the point-to-point link, as defaulted.
You can configure the port (not) to connect with the point-to-point link with either of the
earlier-mentioned measures. For the ports connected with the point-to-point link, upon
some port role conditions met, they can transit to forwarding state fast through
transmitting synchronization packet, thereby reducing the unnecessary forwarding
delay. If the parameter is configured as auto mode, MSTP will automatically detect if the
current Ethernet port is connected with the point-to-point link.
Note:
For a link aggregation, only the master port can be configured to connect with the
point-to-point link. If a port in auto-negotiation mode operates in full-duplex mode
upon negotiation, it can be configured to connect with the point-to-point link.
Operation
the port to connect
Operation
1-28
Chapter 1 MSTP Region-configuration
with the stp interface
point-to-point force-true
stp interface
point-to-point force-false
stp interface
point-to-point auto
undo
interface-list point-to-point
Command
interface-list
interface-list
interface-list
stp interface
Command
stp point-to-point
force-true
stp point-to-point
force-false
stp point-to-point
auto
undo stp
point-to-point