H3C S9500 Series Operation Manual page 1006

Operation Manual – Integrated Management
H3C S9500 Series Routing Switches
You can also perform these configurations locally. Refer to the operation manual of the
switch you are configuring for more information.
IV. Configuring an S2403F Ethernet swtich
Perform the following configuration in lanswitch view.
Table 1-13 Configure an S2403F Ethernet switch
Configure the Ethernet switch using the
default configuration settings
Display the management IP address
and subnet mask of the Ethernet switch
and the IP address of the default
gateway
Set or remove the management IP
address and subnet mask of the
Ethernet switch and the IP address of
the default gateway
Set the management MAC address for
the Ethernet switch
Configure the port tag status, and the
relationship between Ethernet switch
ports and VLANs
Set the VLAN data of the Ethernet
switch
Set working mode for specified ports of
the Ethernet switch
Allow the specified port self loopback
Prohibit the specified port self loopback
Close specified switch ports
Enable specified switch ports
You can use the auto config command to configure specified ports with the default
configuration settings, such as port rate, flow control, duplex state, and tag state. When
executing the auto config command, you must provide the port-start-vlanid argument
to specify the starting VLAN ID of the specified port, through which you can add multiple
ports to one VLAN.
You can perform these configurations locally. Refer to the corresponding operation
manual of the switch you are configuring for more information.
Operation
1-11
Chapter 1 HGMP V1 Configuration
Command
auto config default port-start-vlanid
query ip address
set ip address
[ gateway-address ]
set mac mac-address
set port port-list vlanid vlan-id-list
[ tagged | untagged ]
set vlan vlan-index-list
vlan-id-list [ port-list ] | broadcast
port-list [ vlan-id-list ] }
set workmode port-list { auto | 10m-full
| 10m-half | 100m-full | 100m-half }
loop port port-list
undo loop port port-list
close port port-list
undo close port port-list
ip-address mask
{ vlanid