Pim-Dm Configuration Example - H3C S9500 Series Operation Manual

Operation Manual – Multicast Protocol
H3C S9500 Series Routing Switches
Table 6-9 Displaying and debugging PIM-DM
Display the PIM multicast
routing table
Display the PIM interface
information
Display
about
routers
Display BSR information
Display RP information
Enable the PIM debugging
Disable the PIM debugging
Enable
debugging
Disable
debugging

6.4 PIM-DM Configuration Example

I. Networking requirements
Lanswitch1 is connected to the multicast source through VLAN-interface 10, connected
to Lanswitch2 through VLAN-interface 11 and connected to Lanswitch3 through
VLAN-interface 12. Through running PIM-DM, you can implement multicast among
RECEIVER 1, RECEIVER 12 and Multicast Source.
Operation
the information
PIM neighboring
the PIM-DM
the PIM-DM
Command
display pim routing-table [ { { *g [ group-address
[ mask { mask-length | mask } ] ] | **rp [ rp-address
[ mask { mask-length | mask } ] ] } | { group-address
[ mask { mask-length | mask } ] | source-address
[ mask { mask-length | mask } ] } * } |
incoming-interface interface-type interface-number
| null } | { dense-mode | sparse-mode } ] *
display pim interface
Vlan-interface-number ]
display pim neighbor [ interface Vlan-interface
Vlan-interface-number ]
display pim bsr-info
display pim rp-info [ group-address ]
debugging pim common { all | event | packet |
timer }
undo debugging pim common { all | event | packet
| timer }
debugging pim dm { alert | all | mbr | mrt | timer |
warning | { recv | send } { all | assert | graft |
graft-ack | join | prune } }
undo debugging pim dm { alert | all | mbr | mrt |
timer | warning | { recv | send } { all | assert | graft |
graft-ack | join | prune } }
6-7
Chapter 6 PIM-DM Configuration
[ Vlan-interface