H3C S9500 Series Operation Manual page 988

Operation Manual – NAT-URPF-VPLS
H3C S9500 Series Routing Switches
Table 3-17 Configure VPN broadcast suppression percentage
Configure VPN broadcast suppression
percentage
By default, VPN broadcast suppression percentage is 5%.
III. Configuring packet MTU
Use the mtu command to specify the maximum transmission unit (MTU) value for user
access packets of this VPLS instance, which is in the range of 128 to 8,192. This MTU
value is also the MTU value for PW.
Perform the following configuration in VSI-LDP view.
Table 3-18 Configure packet MTU
Configure packet mtu for the VPLS instance
By default, MTU is 1,500 Bytes.
IV. Configuring the QoS level
Use the command here to configure the QoS level for the VSI, which is in the range of 0
to 7. When configuring the QoS level, you can either use the QoS mapping table
suggested by the protocol, or the user-defined QoS table and set p-p-p-p-p-p-p-p with
this command.
Perform the following configuration in VSI-LDP view.
Table 3-19 Configure the QoS level
Configure the QoS level for the VSI
The default QoS level is 0.
V. Configuring other VPLS characteristics
Perform the following configuration in the corresponding VSI-LDP views.
Operation
Operation
Operation
3-15
Chapter 3 VPLS Configuration
Command
broadcast-restrain restrain-number
Command
mtu mtu
Command
qos { 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 |
{ user-define-table p p p p p p p p } }