H3C S9500 Series Operation Manual page 840

Operation Manual – System Management
H3C S9500 Series Routing Switches
III. Configuration procedure
1) Configure the switch
# Log into the switch through the console port locally or through telnet remotely (refer to
the getting start module for details about the login modes).
<H3C>
# Enable FTP on the switch; configure a username, password and path.
[H3C] ftp server enable
[H3C] local-user switch
[H3C-luser-switch] service-type ftp ftp-directory flash:
[H3C-luser-switch] password simple hello
2) Run the FTP client program on the PC to set up an FTP connection with the switch.
Then upload the switch program switch.app to the flash root directory on the
switch and download the configuration file config.txt from the switch. The FTP
client program is not provided along with the switch, so, it is for you to purchase
and install it.
Caution:
If the Flash Memory on the switch is not sufficient, delete the original application
program in the flash before uploading the new one into the flash of the switch.
3) After uploading, performs upgrading on the switch.
<H3C>
# You can use the boot boot-loader command to specify the new file as the application
program on the next booting and reboot the switch to implement the upgrading of the
application program.
<H3C> boot boot-loader primary flash:/switch.app slot 0
<H3C> reboot
3-8
Chapter 3 Device management