Vpls Basic Configuration Example - H3C S9500 Series Operation Manual

Routing switches

Hide thumbs Also See for S9500 Series:

Table of Contents

Operation Manual – NAT-URPF-VPLS

H3C S9500 Series Routing Switches

3.7 VPLS Basic Configuration Example

I. Network requirements

S9500 series switch support all kinds of VPLS architectures and networking. Figure 3-4

shows a simple back-to-back network diagram. Where, two sites of VPN1 connect to

port E6/1/48 of the two PEs (PE1 and PE2) respectively. Both PEs are configured with

the private VLAN 100 and public VLAN 10 connected through G4/1/1 to implement

basic VPLS service.

II. Network diagram

Figure 3-4 Network diagram for VPLS configuration of back-to back PEs

III. Configuration procedure

The VPLS service processor card is on slot 5, and the common interface card is on slot

Configure PE1

# Configure the Router ID used to advertise OSPF routing information. Generally, the

virtual interface address of both MPLS LSI-ID and Loopback0 can be configured with

the same IP address.

[PE1] router id 5.6.7.8

# Configure MPLS LSI-ID. Enable MPLS and MPLS LDP globally.

[PE1] mpls lsr-id 5.6.7.8

[PE1] mpls ldp

# Configure a 32-bit Loopback address, which is used to create LSP.

[PE1] interface loopback0

[PE1 -LoopBack0] ip address 5.6.7.8 32

Chapter 3 VPLS Configuration

Table of Contents

S9505 S9508 S9512