Enabling/Disabling Stopping Accounting Request Buffer; Setting The Maximum Retransmitting Times Of Stopping Accounting Request - H3C S9500 Series Operation Manual

Operation Manual – Security
H3C S9500 Series Routing Switches
By default, the real-time accounting request can fail to be responded no more than 5
times.

2.3.11 Enabling/Disabling Stopping Accounting Request Buffer

Because the stopping accounting request concerns account balance and will affect the
amount of charge, which is very important for both the subscribers and the ISP, NAS
shall make its best effort to send the request to RADIUS accounting server. Accordingly,
if the request from H3C Series Switches to RADIUS accounting server has not been
responded, switch shall save it in the local buffer and retransmit it until the server
responds or discards the messages after transmitting for specified times. You can use
the following command to set whether or not to save the stopping accounting requests.
Perform the following configuration in RADIUS scheme view.
Table 2-22 Enable/Disable stopping accounting request buffer
Enable stopping accounting request buffer
Disable
buffer
By default, the stopping accounting request will be saved in the buffer.
2.3.12 Setting the Maximum Retransmitting Times of Stopping Accounting
Request
Because the stopping accounting request concerns account balance and will affect the
amount of charge, which is very important for both the subscribers and the ISP, NAS
shall make its best effort to send the message to RADIUS accounting server.
Accordingly, if the request from H3C Series Switch to RADIUS accounting server has
not been responded, switch shall save it in the local buffer and retransmit it until the
server responds or discards the messages after transmitting for specified times. Use
the following command to set the maximum retransmission times.
Perform the following configuration in RADIUS scheme view.
Table 2-23 Set the maximum retransmitting times of stopping accounting request
Set the maximum retransmitting times of
stopping accounting request
Restore the maximum retransmitting
times of stopping accounting request to
the default value
Operation
stopping accounting
Operation
Chapter 2 AAA and RADIUS/HWTACACS
stop-accounting-buffer enable
request
undo
enable
retry stop-accounting retry-times
undo retry stop-accounting
2-22
Protocol Configuration
Command
stop-accounting-buffer
Command