H3C S9500 Series Operation Manual page 854

Operation Manual – System Management
H3C S9500 Series Routing Switches
Table 4-18 Send the configuration information to the trap buffer
Device
Switch
6) Sending the configuration information to SNMP
Table 4-19 Send the configuration information to SNMP
Device
Switch
Network
management
workstation
Configuration
Enable info-center
Set the information
output direction to the
trapbuffer
Set information source
Configuration
Enable
info-center
Set the
information
output direction
to SNMP
Set information
source
Configure SNMP
features
The same as the
SNMP
configuration of
the switch
Chapter 4 System Maintenance and Debugging
Default
Configuration description
value
By default,
Other configurations are valid
info-center
only if the info-center is enabled
is enabled
You can configure the size of the
-
trap buffer at the same time
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You must
-
turn
corresponding
defining
information
Default value Configuration description
By default, Other configurations are valid
info-center is only if the info-center is
enabled enabled
- -
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You
-
must turn on the switch of the
corresponding module before
defining
information
Refer to Chapter 5
-
Configuration
- -
4-14
on the switch of
module before
output debugging
output debugging
SNMP
the