H3C S9500 Series Operation Manual page 59

Operation Manual – Port
H3C S9500 Series Routing Switches
Chapter 2 Ethernet Port Configuration
2.1 Ethernet Port Overview
S9500 series can provide conventional Ethernet ports, fast Ethernet ports, 1000 Mbps
Ethernet ports and 10 Gbps Ethernet ports. The configurations of these Ethernet ports
are basically the same, which will be described in the following sections.
2.2 Ethernet Port Configuration
The following sections describe Ethernet port configuration tasks:
Entering Ethernet Port View
Enabling/Disabling an Ethernet Port
Setting Ethernet Port Description
Setting the Duplex Attribute of the Ethernet Port
Setting Speed on the Ethernet Port
Setting the Cable Type for the Ethernet Port
Enabling/Disabling Flow Control for the Ethernet Port
Enabling/Disabling Jumbo Frames' Passing a Card
Setting Broadcast/Multicast Suppression on Ethernet Port
Setting the Ethernet Port Mode
Setting the Link Type for the Ethernet Port
Adding the Ethernet Port to Specified VLANs
Setting the Default VLAN ID for the Ethernet Port
Setting the VLAN VPN Feature on a Port
Copying Port Configurations to Other Ports
Setting Port Hold Time
Setting the Ethernet Port in Loopback Mode
2.2.1 Entering Ethernet Port View
Before configuring the Ethernet port, enter Ethernet port view first.
Perform the following configuration in system view.
Table 2-1 Entering Ethernet port view
Enter Ethernet port view
Operation
Chapter 2 Ethernet Port Configuration
Command
interface interface-type interface-number
2-1