H3C S9500 Series Operation Manual page 461

Operation Manual – Multicast Protocol
H3C S9500 Series Routing Switches
By default, no routing policy is specified for any peer (group).
VIII. Configuring IP-ACL-based route filtering policy for a peer (group)
Please perform the following configurations in IPV4 multicast sub-address family view.
Table 9-9 Configuring IP-ACL-based route filtering policy for a peer (group)
Configure
incoming packets
Remove
configuration
Configure
outgoing packets
Remove
configuration
By default, a peer (group) does not perform route filtering based on the IP ACL.
IX. Configuring AS-path-list-based route filtering policy for a peer (group)
Please perform the following configurations in IPV4 multicast sub-address family view.
Table 9-10 Configuring the AS-path-list-based route filtering policy for a peer (group)
Configure filtering policy
for incoming packets
Remove incoming policy
configuration
Configure routing policy
for outgoing packets
Remove outgoing policy
configuration
By default, a peer (group) does not perform route filtering based on the AS path list.
X. Configuring prefix-list-based route filtering policy for a peer (group)
Please perform the following configurations in IPV4 multicast sub-address family view.
Operation
filtering policy
incoming policy
routing policy
outgoing policy
Operation
peer { group-name | peer-address } as-path-acl
acl-number import
undo peer { group-name | peer-address } as-path-acl
acl-number import
peer group-name as-path-acl acl-number export
undo peer group-name as-path-acl acl-number
export
Chapter 9 MBGP Multicast Extension Configuration
for peer { group-name
filter-policy acl-number import
undo peer { group-name | peer-address }
filter-policy acl-number import
for peer group-name filter-policy acl-number
export
undo peer
acl-number export
Command
9-8
Command
| peer-address
group-name filter-policy
}