H3C S9500 Series Operation Manual page 1005

Operation Manual – Integrated Management
H3C S9500 Series Routing Switches
You can use the auto config command to configure specified ports with the default
configuration settings, such as port rate, flow control, duplex state, and tag state. When
executing the auto config command, you must provide the port-start-vlanid argument
to specify the starting VLAN ID of the specified port, through which you can add multiple
ports to one VLAN.
You can perform these configurations locally. Refer to the corresponding operation
manual of the switch you are configuring for more information.
III. Configuring the address table for a specified switch
These operations are applicable to S2008B/S2016B/S2026B/S3026 series Ethernet
switches.
Perform the following configuration in lanswitch view.
Table 1-12 Configure the address table for a S2008B/S2016B/S2026B/S3026 series
switch
Add an address entry
Remove a multicast address entry
Remove an unicast address entry
Modify a multicast address entry
Modify an unicast address entry
Search
addresses in the address table
Search specified unicast addresses
in the address table
Display the unicast address entries
of a specified port
Display the multicast address entries
in a specified VLAN
Query the number of the occupied
address entries
Query the current configuration of
the connected switches
Query the startup configuration of
the connected switches
Operation
specified multicast
1-10
Chapter 1 HGMP V1 Configuration
Command
add addritem mac-addr { unicast port
[ aged | noaged | permanent ] | multicast
vlanid port-list mctype }
delete multicast mac-addr vlanid vlanid
delete uniaddr mac-addr
modify multiaddr mac-addr vlanid port-list
mctype
modify uniaddr mac-addr { aged | noaged
| permanent }
search multiaddr mac-addr-list vlanid
vlanid-list
search uniaddr mac-addr-list
query uniaddr port
shownum
query multiaddr vlanid vlanid
query used addrnum
query active-configuration
query saved-configuration
spec-port index