Displaying And Maintaining Bulk Interface Configuration - H3C S7500E Series Instruction Manual

Step
2. Enter interface range
view.
3. (Optional.) Display
commands available for
the first interface in the
interface range.
4. Use available
commands to configure
the interfaces.
5. (Optional.) Verify the
configuration.
Displaying and maintaining bulk interface
configuration
Execute the display command in any view.
Task
Display information about the interface ranges
created by using the interface range name
command.
Command
•
interface range
{ interface-type
interface-number [ to
interface-type
interface-number ] } &<1-24>
•
interface range name name
[ interface { interface-type
interface-number [ to
interface-type
interface-number ] }
&<1-24> ]
Enter a question mark (?) at the
interface range prompt.
Available commands depend on
the interface.
display this
Command
display interface range [ name name ]
2
Remarks
By using the interface range name
command, you assign a name to an
interface range and can specify this
name rather than the interface range
to enter the interface range view.
N/A
N/A
N/A