H3C S9500 Series Operation Manual page 860

Operation Manual – System Management
H3C S9500 Series Routing Switches
Table 4-29 Configure to output information to Telnet terminal or dumb terminal
Output information to Telnet terminal or
dumb terminal
Cancel the configuration of outputting
information to Telnet terminal or dumb
terminal
3) Configuring information source on the switch
By this configuration, you can define the information that sent to Telnet terminal or
dumb terminal is generated by which modules, information type, information level, and
so on.
Perform the following configuration in system view:
Table 4-30 Define information source
Define information source
Cancel the configuration of
information source
modu-name specifies the module name; default represents all the modules; all
represents all the information filter configuration in channel channel-number except
default; level refers to the severity levels; severity specifies the severity level of
information. The information with the level below it will not be output. channel-number
specifies the channel number and channel-name specifies the channel name.
When defining the information sent to Telnet terminal or dumb terminal,
channel-number or channel-name must be set to the channel that corresponds to
monitor direction.
Every channel has been set with a default record, whose module name is default and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Operation
Operation
Chapter 4 System Maintenance and Debugging
info-center
{ channel-number | channel-name }
undo info-center monitor channel
Command
info-center source { modu-name | default }
channel { channel-number | channel-name }
[ debug { level severity | state state }* | log { level
severity | state state }* | trap { level severity | state
state }* ]*
undo info-center source { modu-name | default |
all } channel { channel-number | channel-name }
4-20
Command
monitor channel