H3C S9500 Series Operation Manual page 115

Operation Manual – VLAN-QinQ
H3C S9500 Series Routing Switches
Table 1-3 Name the current VLAN
Name the current VLAN
Restore the default name of the current VLAN
By default, the name of the current VLAN is its VLAN ID.
1.2.4 Creating/Removing a VLAN Interface
You can use the following commands to create/remove a VLAN interface. To implement
the network layer function on a VLAN interface, IP address and mask should be set to
the VLAN interface. For corresponding configuration, refer to "Network protocol" part in
this manual.
Perform the following configuration in system view.
Table 1-4 Create/remove a VLAN interface
Create a new VLAN interface and enter
the VLAN interface view
Remove a specified VLAN interface
Create a VLAN before creating a VLAN interface corresponding to the VLAN.
1.2.5 Shutting down/Bringing up a VLAN Interface
You can use the following commands to shut down/bring up a VLAN interface.
Perform the following configuration in VLAN interface view.
Table 1-5 Shut down/bring up a VLAN interface
Shut down a VLAN interface
Bring up a VLAN interface
Shutting down or bringing up a VLAN interface has no effect on the status of any
Ethernet port in this VLAN.
By default, when all the Ethernet ports in a VLAN are in the Down state, this VLAN
interface is also Down. When there are one or more Ethernet ports in the Up state, this
VLAN interface is also Up.
Operation
Operation
Operation
1-3
Chapter 1 VLAN Configuration
Command
name
undo name
Command
interface vlan-interface vlan-id
undo interface vlan-interface vlan-id
Command
shutdown
undo shutdown