Specifying The Bootstrap Programs For The Routing Switch - H3C S9500 Series Operation Manual

Operation Manual – System Management
H3C S9500 Series Routing Switches
Table 3-2 Enable the Timing Reboot Function
Enable the timing reboot function of the
switch, and set specified time and date
Enable the timing reboot function of the
switch, and set waiting time
Cancel the parameter configuration of timing
reboot function of the switch
Check the parameter configuration of the
reboot terminal service of the current switch
Note:
The precision of switch timer is 1 minute. The switch will reboot in one minute when
time comes to the specified rebooting point.

3.2.3 Specifying the Bootstrap Programs for the Routing Switch

You can specify two bootstrap programs for both active and standby SRPCs of the
routing switch, with one used as the primary program and the other as the backup
program. You can use the following command to specify the bootstrap programs for the
routing switch:
Table 3-3 Specify a bootstrap program for the switch
Operation
Specify the bootstrap
program for the switch
If the switch fails to boot up through the specified bootstrap program, it retries to boot up
by using a program in the flash memory or the CF card. If it fails again, the switch fails to
start.
The switch select one application program as bootstrap program from Flash or CF card
according to the different values of flag BootDev. The detail is as follows:
There are two primary bootstrap programs: one is in the Flash card (assume it is
A); the other is in the CF card (assume it is B).
There are two backup programs too: one is in the Flash card (assume it is C); the
other is in the CF card (assume it is D).
There is one flag BootDev.
Operation
Command
boot boot-loader { primary |
backup }
slot-number ]
3-2
Chapter 3 Device management
Command
schedule reboot
[ yyyy/mm/dd ]
schedule reboot delay { hhh:mm |
mmm }
undo schedule reboot
display schedule reboot
Execute this command
file-url [ slot
in user view.
at hh:mm
Description