H3C S9500 Series Operation Manual page 645

Operation Manual – MPLS
H3C S9500 Series Routing Switches
Check whether the loopback interface configured on the PE has the address with
32-bit mask.
Check whether the tag of private network route is correct.
Check whether the LDP session is established using the display mpls ldp
session command.
Check whether the LSP tunnel is established using the display mpls lsp
command.
III. Symptom 3
In Hub&Spoke networking mode, spoke PE cannot learn the private networking route of
Hub PE.
Solution:
Check whether the LSP tunnel is established using the display mpls lsp
command.
Check whether the BGP adjacent is established correctly.
Check whether the routing import/export relation of the VPN-instance is correct.
Check whether allow-as-loop is configured between spoke PE and hub PE.
IV. Symptom 4
Fall to specify the Loopback interface at the peer end as the BGP neighbor.
Solution:
Check whether the local routing table has learnt the Loopback interface routing
information of the peer end using the display ip routing-table command.
Check whether the address of the Loopback interface at the peer end can be
pinged using the ping command.
Check whether the configuration information is correct using the display
current-configuration bgp command; confirm that you have specified the local
loopback interface as the interface to create adjacent interface with the peer end
by using the peer peer-address connect-interface command; confirm that you
have activate the neighbor in VPNv4 sub-address family view.
Check whether the BGP information is correct on the PE at the peer end; check
whether specified the local Loopback interface as the interface to create adjacent
with the peer end; and check whether you have configured VPN capacity.
V. Symptom 5
During ASBR configuration, VPN route interior label does not switch on the ASBR.
Solution:
Check whether the VPN neighbor is created correctly using the display bgp
vpnv4 all peer command.
Check whether ASBR is configured with the undo policy vpn-target command. If
not, configure this command.
Chapter 3 BGP/MPLS VPN Configuration
3-85