Ssh Client Configuration Example - H3C S9500 Series Operation Manual

Routing switches
Hide thumbs Also See for S9500 Series:
Table of Contents

Advertisement

Operation Manual – System Management
H3C S9500 Series Routing Switches

8.1.6 SSH Client Configuration Example

I. Network requirements
As shown in Figure 8-4:
Switch A is used as an SSH client.
Switch B is used as the SSH server, and the IP address is 10.165.87.136.
II. Network diagram
Switch B
Switch B
SSH server
IP address :
IP address
PC
PC
Figure 8-4 Network diagram for SSH client
III. Configuration procedure
Configure the client to perform the first-time authentication of the server.
Employ password authentication mode, and start using the default encryption
algorithm.
# Log onto the SSH2 server with IP address 10.165.87.136.
[H3C] ssh2 10.165.87.136
Please input the username:sshuser1
Trying 10.165.87.136
Press CTRL+K to abort
Connected to 10.165.87.136 ...
Enter password:
*********************************************************
*
*
Without the owner's prior written consent,
*no decompiling or reverse-engineering shall be allowed.*
*********************************************************
<H3C>
# Configure the client to authenticate the server for the first time.
<H3C> system-view
10.165.87.136
SSH client
All rights reserved (1997-2004)
Chapter 8 SSH Terminal Service
Switch A
Switch A
8-14
*
*

Advertisement

Table of Contents
loading

This manual is also suitable for:

S9505S9508S9512

Table of Contents