Creating A Vpls Instance - H3C S9500 Series Operation Manual

Operation Manual – NAT-URPF-VPLS
H3C S9500 Series Routing Switches
By default, MPLS L2VPN is disabled.

3.5.5 Creating a VPLS Instance

I. Specifying a VPLS instance name
Use the vsi command to create a VPLS instance or enter VSI view. When creating a
VPLS instance, you must specify a locally unique VPLS instance name, and choose
automatic discovery or manual configuration as peer discovery mechanism (currently,
only manual configuration is supported).
Table 3-6 Specify a VPLS instance name
Specify a VPLS instance name
Remove a VPLS instance or quit the VSI
view
II. Entering VSI-LDP view and configuring VSI-ID
Use the pwsignal command to specify a PW signaling protocol used by VPLS and
enter VPLS protocol view.
When you specify Martini as the VPLS connection mode (MPLS L2VPN in Martini
mode adopts expanded LDP to send signaling of VC information), you will enter
VSI-LDP view at the same time.
Perform the following configuration in VSI view.
Table 3-7 Specify Martini as the VPLS connection mode
Specify martini as the VPLS connection mode
By default, VPLS adopts Martini mode.
Use the vsi-id command to specify the ID of a VPLS instance. The ID ranges from 1 to
1,024, and must be locally unique.
Perform the following configuration in VSI-LDP view.
Table 3-8 Configure a VPLS instance
Specify a ID for a VPLS instance
Operation
Operation
Operation
3-9
Chapter 3 VPLS Configuration
Command
vsi vsi-name
[ encapsulation { ethernet | vlan } ]
undo vsi vsi-name
Command
pwsignal [ ldp ]
Command
vsi-id vsi-id
[ static ]