H3C S9500 Series Operation Manual page 1003

Operation Manual – Integrated Management
H3C S9500 Series Routing Switches
Table 1-10 Enter the configuration view of a specified Ethernet switch
Enter the configuration view of a specified
Ethernet switch
You can configure port rate, port aggregation, VLAN, and so on for a specified switch
on the management device only after you enter the configuration view of the specified
Ethernet switch on the management device.
II. Performing port, VLAN and other configurations for a specified switch
These operations are applicable to S2008B/S2016B/S2026B/S3026 series Ethernet
switches.
Perform the following configuration in lanswitch view.
Table 1-11 Perform port, VLAN and other configurations for a specified switch
Aggregate multiple ports to one port
Disable the address learning function of
the port of the switch
Query address aged time of the switch
Query gateway IP address of the switch
Query manage IP address of the switch
Query lock state of the port of the switch
Query system information of the switch
Query VDLS link rates of the port
Query VLAN state information of the
switch
Set address aged time of the switch
Set the gateway IP address of the switch
Cancel the setting of gateway IP
address of the switch
Set the management IP address of the
switch
Cancel the setting of the management
IP address of the switch
Set the VDSL link rates of the port of the
switch
Operation
Operation
1-8
Chapter 1 HGMP V1 Configuration
Command
lanswitch lanswitch-loc
Command
set link-aggregation port-list { sa |
dasa } groupid
lock port port-list
query address agedtime
query gatewayip
query manageip vlan-id
query port lockstate
query system info
query vdsllink [ port-list ]
query vlanstate
set address agedtime agedtimevalue
set gatewayip ip-address
undo set gatewayip ip-address
set manageip ip-address netmask
[ vlan-id ]
undo set manageip
netmask [ vlan-id ]
set vdsllink port-list uprate uprate-list
downrate downrate-list
ip-address