Downloading Files By Means Of Tftp - H3C S9500 Series Operation Manual

Operation Manual – System Management
H3C S9500 Series Routing Switches
Switch Switch Switch
Figure 1-4 TFTP configuration
Table 1-17 lists the configuration of the switch as TFTP client.
Table 1-17 Configuration of the switch as TFTP client
Device
Switch
PC

1.4.2 Downloading Files by Means of TFTP

To download a file, the client sends a request to the TFTP server and then receives
data from it and sends acknowledgement to it. You can use the following commands to
download files by means of TFTP.
Perform the following configuration in user view.
Table 1-18 Download files by means of TFTP
Download files by means of TFTP
In the command, tftp-server indicates the IP address or host name of TFTP server;
source-file indicates the file information to be downloaded from TFTP server; dest-file
indicates the name of the file downloaded on switch.
Network Network
Configuration
Configure IP address for
the VLAN interface of
the switch, in the same
network segment as that
of TFTP server.
Use the tftp command to
log into the remote TFTP
server for file uploading
and downloading.
Start TFTP server and
set authorized TFTP
directory.
Operation
Chapter 1 File System Management
PC PC
Default
TFTP is right for the case where no
complicated
required between the client and
-
server. Make sure that the route is
reachable between the switch and
the TFTP server.
- -
- -
tftp tftp-server get source-file [ dest-file ]
1-15
Description
interactions
Command
are