H3C S9500 Series Operation Manual page 65

Operation Manual – Port
H3C S9500 Series Routing Switches
be sent without tags, but the trunk port only allows the packets from the default VLAN to
be sent without tags.
Perform the following configuration in Ethernet port view.
Table 2-11 Setting the link type for the Ethernet port
Configure the port as access port
Configure the port as hybrid port
Configure the port as trunk port
Restore the default link type, that is, the
access port
You can configure three types of ports concurrently on the same switch, but you cannot
switch between trunk port and hybrid port. You must turn it first into access port and
then set it as other type. For example, you cannot configure a trunk port directly as
hybrid port, but first set it as access port and then as hybrid port.
By default, the port is access port.
2.2.12 Adding the Ethernet Port to Specified VLANs
The following commands are used for adding an Ethernet port to a specified VLAN. The
access port can only be added to one VLAN, while the hybrid and trunk ports can be
added to multiple VLANs.
Perform the following configuration in Ethernet port view.
Table 2-12 Adding the Ethernet port to specified VLANs
Add the current access port to a
specified VLAN
Add the current hybrid port to specified
VLANs
Add the current trunk port to specified
VLANs
Remove the current access port from to
a specified VLAN
Remove the current hybrid port from to
specified VLANs
Remove the current trunk port from
specified VLANs
Operation
Operation
2-7
Chapter 2 Ethernet Port Configuration
Command
port link-type access
port link-type hybrid
port link-type trunk
undo port link-type
Command
port access vlan vlan-id
port hybrid vlan vlan-id-list { tagged |
untagged }
port trunk permit vlan { vlan-id-list |
all }
undo port access vlan
undo port hybrid vlan vlan-id-list
undo port trunk
{ vlan-id-list | all }
permit vlan