Configuring Radius Protocol - H3C S9500 Series Operation Manual

Operation Manual – Security
H3C S9500 Series Routing Switches
Table 2-10 Configure the name of a delivered VLAN
Configure the name of a delivered VLAN
Remove the configured VLAN name and
restore it to the default name
By default, the delivered VLAN does not have a name.

2.3 Configuring RADIUS Protocol

For the H3C Series Switches, the RADIUS protocol is configured on the per RADIUS
scheme basis. In real networking environment, a RADIUS scheme can be an
independent RADIUS server or a set of primary/secondary RADIUS servers with the
same configuration but two different IP addresses. Accordingly, attributes of every
RADIUS scheme include IP addresses of primary and secondary servers, shared key
and RADIUS server type etc.
Actually, RADIUS protocol configuration only defines some necessary parameters
using for information interaction between NAS and RADIUS Server. To make these
parameters take effect on an ISP domain, you must configure the ISP domain to use
the RADIUS scheme configured with these parameters in ISP domain view. For more
about the configuration commands, refer to the AAA Configuration section above.
The following sections describe RADIUS protocol configuration tasks.
Creating/Deleting a RADIUS scheme
Setting IP Address and Port Number of a RADIUS Server
Setting the RADIUS Packet Encryption Key
Configuring VPN of RADIUS Server
Setting the Maximum Retry Times for RADIUS Request Packets
Setting RADIUS Server
Setting Quiet Time of RADIUS Server
Enabling the Selection of Radius Accounting Option
Setting a Real-time Accounting Interval
Setting the Maximum Times of Real-time Accounting Request Failing to be
Responded
Enabling/Disabling Stopping Accounting Request Buffer
Setting the Maximum Retransmitting Times of Stopping Accounting Request
Setting the Supported Type of RADIUS Server
Setting RADIUS Server State
Setting the Username Format Transmitted to RADIUS Server
Setting the Unit of Data Flow that Transmitted to RADIUS Server
Configuring a Local RADIUS Authentication Server
Operation
2-14
Chapter 2 AAA and RADIUS/HWTACACS
Command
name string
undo name
Protocol Configuration