H3C S9500 Series Operation Manual page 280

Routing switches

Hide thumbs Also See for S9500 Series:

Table of Contents

Operation Manual – Routing Protocol

H3C S9500 Series Routing Switches

5.1.3 NSAP Structure of IS-IS Routing Protocol

I. Address structure

Figure 5-2 NSAP structure

OSI adopts the address structure as shown in Figure 5-2. NSAP includes initial domain

part (IDP) and domain specific part (DSP). The IDP is defined by ISO; it consists of

authority responsible for assigning the rest of the address and address format. The

DSP is allocated by the authority specified in IDP. IDP and DSP are length-variable with

a total length of 20 bytes.

Area Address

IDP includes authority and format identifier (AFI) and initial domain identifier (IDI). AFI

defines the format of IDI. DSP has several bytes. The combination of IDP and HO-DSP

can identify a route area and an area of the route area, so the combination is called an

area address.

In general, you only need to configure an area address for a router. The area addresses

of all nodes are the same in an area. To support the seamless combination,

segmentation and conversion, S9500 series support up to three area addresses.

System ID uniquely identifies terminal system or router in a route area. You can select

length for it. For S9500 series, System ID length is 48 bits (6 bytes). In general, you can

obtain System ID according to Router_ID.

If the IP address 168.10.1.1 of the interface LoopBack0 serves as a router_ID for the

router, you can use the following method to obtain the System ID:

Turn each part of the IP address 168.10.1.1 into three digits. Add 0 to the front of the

part less than three digits.

Divide the expanded address 168.010.001.001 into three parts. Each part contains four

You get the System ID 1680.1000.1001.

High Order DSP

Area Address

Chapter 5 Integrated IS-IS Configuration

Chapters

Table of Contents

S9505 S9508 S9512