H3C S9500 Series Operation Manual page 920

Operation Manual – System Management
H3C S9500 Series Routing Switches
Table 8-7 Configure the number of SSH authentication retries
Configure
authentication retries
Restore the default number of SSH
authentication retries
By default, the number of authentication retries is 3.
VII. Entering the public key view
Use this configuration command to enter the public key view and specify the name of
the public key of the client.
Perform the first configuration in the following table in system view.
Table 8-8 Public key configuration
Enter the public key view
Exit the public view and return to the
system view
Note:
The configuration commands are applicable to the environments where the server
employs RSA authentication on SSH users. If the server adopts password
authentication on SSH users, these configurations are not necessary.
VIII. Entering the public key edit view
After entering the public key view by the rsa peer-public-key command, you can use
the public-key-code begin command to enter the public key edit view and input the
public key of the client.
When inputting the public key, you may type spaces between the characters (the
system will delete the spaces automatically), or press <Enter> and then continue to
input the key. Note that the public key must be a hexadecimal string coded in the public
key format.
Perform the following configuration in public key view.
Operation
the number of
Operation
8-8
Chapter 8 SSH Terminal Service
SSH
ssh server authentication-retries times
undo ssh server authentication-retries
rsa peer-public-key key-name
peer-public-key end
Command
Command