Sending The Configuration Information To Console Terminal - H3C S9500 Series Operation Manual

Operation Manual – System Management
H3C S9500 Series Routing Switches
By this configuration, you can define the information that sent to console terminal is
generated by which modules, information type, information level, and so on.
Perform the following configuration in system view.
Table 4-22 Define information source
Define information source
Cancel the configuration of
information source
modu-name specifies the module name; default represents all the modules; all
represents all the information filter configuration in channel channel-number except
default; level refers to the severity levels; severity specifies the severity level of
information. The information with the level below it will not be output. channel-number
specifies the channel number and channel-name specifies the channel name.
When defining the information sent to the loghost, channel-number or channel-name
must be set to the channel that corresponds to loghost direction.
Every channel has been set with a default record, whose module name is default and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Note:
If you want to view the debugging information of some modules on the switch, you must
select debugging as the information type when configuring information source,
meantime using the debugging command to turn on the debugging switch of those
modules.
4) Configuring the loghost
The configuration on the loghost must be the same with that on the switch. For related
configuration, see the configuration examples in the later part.

4.5.4 Sending the Configuration Information to Console terminal

To send configuration information to console terminal, follow the steps below:
Operation
Chapter 4 System Maintenance and Debugging
Command
info-center source { modu-name | default }
channel { channel-number | channel-name }
[ debug { level severity | state state }* | log { level
severity | state state }* | trap { level severity | state
state }* ]*
undo info-center source { modu-name | default |
all } channel { channel-number | channel-name }
4-16