Hardware Management And Maintenance; Displaying Hardware Information; Displaying Software And Hardware Version Information; Displaying Running Status Data - H3C SecPath U200 Series Installation Manual

Hardware management and maintenance

This chapter describes how to display running information for the UTM device, verify and diagnose
transceiver modules, troubleshoot system exceptions, and reboot the UTM device.
NOTE:
The output depends on your software version.

Displaying hardware information

Displaying software and hardware version information

Use the display version command to display software and hardware version information for the UTM
device.
<Sysname> display version
H3C Comware Platform Software
Comware Software, Version 5.20, Release 5140
Copyright (c) 2004-2013 Hangzhou H3C Tech. Co., Ltd. All rights reserved.
H3C SecPath U200-S uptime is 0 week, 0 day, 0 hour, 6 minutes
CPU type: XXX
512M bytes DDR2 SDRAM Memory
32M bytes Flash Memory
247M bytes CF0 Card
PCB
Logic
Basic BootWare Version: 1.36
Extend BootWare Version: 1.36
[FIXED PORT] CON
[FIXED PORT] GE0/0
[FIXED PORT] GE0/1
[FIXED PORT] GE0/2
[FIXED PORT] GE0/3
[FIXED PORT] GE0/4
[SUBCARD 1] The SubCard is not present
[SUBCARD 2] The SubCard is not present

Displaying running status data

For diagnosis or troubleshooting, you can use the display diagnostic-information command in any view
to bulk collect running data for multiple modules, rather than using separate display commands (such
as display clock, display version, display device, and display current-configuration) to collect running
status data module by module.
Version:Ver.B
Version: 2.0
(Hardware)Ver.B, (Driver)1.0,
(Hardware)Ver.B, (Driver)1.0,
(Hardware)Ver.B, (Driver)1.0,
(Hardware)Ver.B, (Driver)1.0,
(Hardware)Ver.B, (Driver)1.0,
(Hardware)Ver.B, (Driver)1.0,
(Cpld)2.0
(Cpld)2.0
(Cpld)2.0
(Cpld)2.0
(Cpld)2.0
(Cpld)2.0
43