Enabling/Disabling Quiet-Period Timer; Displaying And Debugging 802.1X - H3C S9500 Series Operation Manual

Operation Manual – Security
H3C S9500 Series Routing Switches
Supplicant does not respond back with authentication reply packet successfully, then
the Authenticator will resend the authentication request packet.
tx-period-value: Specifies how long the duration of the transmission timeout timer is.
The value ranges from 10 to 120 in units of second and defaults to 30.
Note:
It is recommended to configure different handshake period value and handshake
timeout times according to the number of users:
When the number of users is 2048, the handshake period value should be no
smaller than 2 minutes, and the handshake timeout times should be no less
than 3 times;
When the number of users is 1024, the handshake period value should be no
smaller than 1 minutes, and the handshake timeout times should be no less
than 3 times
When the number of users is 512, the handshake period value should be no
smaller than 30 seconds, and the handshake timeout times should be no less
than 2 times.

1.2.11 Enabling/Disabling Quiet-Period Timer

You can use the following commands to enable/disable a Quiet-Period timer of an
Authenticator (such as a H3C Series Switch). If an 802.1x user has not passed the
authentication, the Authenticator will keep quiet for a while (which is specified by dot1x
timer quiet-period command) before launching the authentication again. During the
Quiet Period, the Authenticator does not do anything related to 802.1x authentication.
Perform the following configuration in system view.
Table 1-11 Enable/Disable a Quiet-Period timer
Enable a quiet-period timer
Disable a quiet-period timer
By default, Quiet-Period timer is disabled.

1.3 Displaying and Debugging 802.1x

After the above configuration, execute display dot1x command in any view to display
the running of the 802.1x configuration, and to verify the effect of the configuration.
Operation
1-10
Chapter 1 802.1x Configuration
Command
dot1x quiet-period
undo dot1x quiet-period