H3C S9500 Series Operation Manual page 939

Operation Manual – PoE
H3C S9500 Series Routing Switches
No
3
4
5
6
7
8
9
To cancel the configurations, use the corresponding undo commands. For details
about the parameters, refer to the Command Manual.
Item
Enable PoE on
poe enable
the port
Set the maximum
PoE power poe
supplied by the max-power
port
Set the PoE poe mode { signal |
mode on the port spare | auto }
Set the PoE
poe priority { critical |
priority on the
high | low }
port
Display the PoE display
state of a specific [
or all ports of the interface-type
switch interface-num ]
Display the PoE
power display
information of a power [ interface-name |
specific or all interface-type
ports of the interface-num ]
switch
Display the PoE
status and PoE
power display poe pse
information of
each card
Command
max-power
poe interface
interface-name |
poe interface
1-3
Chapter 1 PoE Configuration
Description
By default, PoE is disabled
on a port.
You can set the maximum
PoE power supplied by a
port depending on the
power of the actual PD. By
default, the max-power is
16800 mW.
S9500 series supports
only signal line PoE mode.
By default, the PoE mode
on a port is signal.
You can set the PoE
priority on a
depending on the practical
situation. By default, the
PoE priority on a port is
low.
You can execute
command in any view.
Executing the display poe
interface command
without any option displays
the PoE status of all the
ports.
You can execute
command in any view.
Executing the display poe
interface power
command without
option displays the PoE
power information about
all the ports.
You can execute
command in any view
port
this
this
any
this