H3C S9500 Series Operation Manual page 863

Operation Manual – System Management
H3C S9500 Series Routing Switches
Table 4-34 Configure to output information to log buffer
Output information to log buffer
Cancel
outputting information to log buffer
By default, the switch outputs information to the log buffer in the CPU. The size of the
log buffer is 512.
3) Configuring information source on the switch
By this configuration, you can define the information that sent to log buffer is generated
by which modules, information type, information level, and so on.
Perform the following configuration in system view:
Table 4-35 Define information source
Define information source
Cancel the configuration of
information source
modu-name specifies the module name; default represents all the modules; all
represents all the information filter configuration in channel channel-number except
default; level refers to the severity levels; severity specifies the severity level of
information. The information with the level below it will not be output. channel-number
specifies the channel number and channel-name specifies the channel name.
When defining the information sent to log buffer, channel-number or channel-name
must be set to the channel that corresponds to logbuffer direction.
Every channel has been set with a default record, whose module name is default and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Operation
the configuration
Operation
Chapter 4 System Maintenance and Debugging
info-center
{ channel-number | channel-name } | size
buffersize ]*
of
undo info-center logbuffer [ channel | size ]
Command
info-center source { modu-name | default }
channel { channel-number | channel-name } [ debug
{ level severity | state state }* | log { level severity |
state state }* | trap { level severity | state state }* ]*
undo info-center source { modu-name | default |
all } channel { channel-number | channel-name }
4-23
Command
logbuffer [ channel