User Manual
H3C XE 200/2000 IP PBX G-Remote
Chapter 2 GUI Server Configuration
2.1 GUI Server Configuration Prerequisites
On the XE IP PBX, the interface connected to Ethernet is configured with a correct IP
address and subnet mask, and is reachable to the PC running the GUI client software.
2.2 GUI Server Configuration Procedure
2.2.1 Enabling the GUI Server
Configure to enable the GUI server as follows:
Table 2-1 GUI server configuration
Enter system view
Enter GUI server
configuration view
Configure the interface
number and port number
for the GUI server
Enable the GUI server
Use the stop command to disable the GUI server.
2.2.2 Displaying the User Information List
Run the display gui-user command in any view to display the administrator
information list.
Operation
system-view
gui
gui-config interface
interface-type
slot-number [ port port ]
start
Chapter 2 GUI Server Configuration
Command
2-1
Remarks
—
—
Required.
The port number is
optional. The GUI client
communicates with the
GUI server through the
port. The port number
ranges from 1 to 65535
and defaults to 10,999.
Required