H3C S9500 Series Operation Manual page 116

Operation Manual – VLAN-QinQ
H3C S9500 Series Routing Switches
1.3 Configuring Port-Based VLAN
1.3.1 Adding Ethernet Ports to a VLAN
You can use the following commands to add the Ethernet ports to a VLAN.
Perform the following configuration in VLAN view.
Table 1-6 Add Ethernet ports to a VLAN
Add Ethernet ports to a VLAN
Remove Ethernet ports from a VLAN
By default, the system adds all the ports to a default VLAN whose ID is 1.
Note that you can add/remove the trunk and Hybrid ports to/from a VLAN by the
port/undo port commands in Ethernet port view, but not in VLAN view.
1.4 Configuring Protocol-Based VLAN
The following sections describe the protocol-based VLAN configuration tasks:
Creating/Deleting a VLAN Protocol Type
Associating/Dissociating a Port with/from a Protocol-Based VLAN
1.4.1 Creating/Deleting a VLAN Protocol Type
You can use the following commands to create/delete a VLAN protocol type.
Perform the following configuration in VLAN view.
Table 1-7 Create/Delete a VLAN protocol type
Create a VLAN protocol type
Delete an existing VLAN
protocol type
1.4.2 Associating/Dissociating a Port with/from a Protocol-Based VLAN
Perform the following configuration in Ethernet port view.
Operation
Operation
port interface-list
undo port interface-list
Command
protocol-vlan [ protocol-index ] { at | ipx
{ ethernetii | llc | raw | snap } { ipv4 ip-address
[ net-mask ] | mode { ethernetii etype etype-id | llc
dsap dsap-id ssap ssap-id | snap etype
etype-id } }
undo protocol-vlan
protocol-end ] | all }
1-4
Chapter 1 VLAN Configuration
Command
{ protocol-index [ to