Displaying Nat Configuration - H3C S9500 Series Operation Manual

Routing switches
Hide thumbs Also See for S9500 Series:
Table of Contents

Advertisement

Operation Manual – NAT-URPF-VPLS
H3C S9500 Series Routing Switches
The version-number parameter indicates the version of the log packets.
By default, the version is 1.
VI. Setting NAT logging mode
Choose one of the following two NAT logging modes:
Perform logging only when a NAT connection is deleted.
Perform logging when a NAT connection is established and deleted.
Use the ip userlog nat mode flow-begin command to make the NAT server start
logging when a NAT connection is established.
Perform the following configuration in system view.
Table 1-19 Set NAT logging mode
Set to start logging when a connection is
established
Restore the default logging mode
By default, the NAT server performs logging only when a NAT connection is deleted.

1.4 Displaying NAT Configuration

After the above configurations, execute the display command in any view to display
and verify NAT configurations.
You can clear the NAT mapping table by using the reset nat session command in user
view.
Table 1-20 Display NAT configuration
Display the configuration of the address pool
Display the aging time of NAT table entries for
various protocols
Display the configurations and operation
states of blacklists
Display
associations
Display all information about the internal
servers
Display the statistics of the current NAT
information
Operation
Operation
the
configuration
ip userlog nat mode flow-begin
undo ip userlog nat mode flow-begin
display nat address-group
display nat aging-time
display nat blacklist { all | ip
ip-address slot slot-no }
of
all
NAT
display nat outbound
display nat server
display nat statistics
1-17
Chapter 1 NAT Configuration
Command
Command

Advertisement

Table of Contents
loading

This manual is also suitable for:

S9505S9508S9512

Table of Contents