H3C S9500 Series Operation Manual page 85

Operation Manual – Port
H3C S9500 Series Routing Switches
Table 4-1 Entering POS port view
Enter POS port view
4.2.2 Adding/Deleting POS Port into/from VLAN
You can add the current POS port into a designated VLAN, so that it can forward the
packets of that VLAN. If the VLAN already contain other ports, you cannot add a POS
port into it, vice versa.
Perform the following configuration in POS port view.
Table 4-2 Adding/deleting POS port into/from VLAN
Add a POS port into the VLAN
Delete a POS port from the VLAN
Note that:
The VLAN added to the POS port must be existent and is configured with the
corresponding VLAN interface and IP address. In addition, it cannot be VLAN 1.
If there are ports of all types in this VLAN, then the POS port cannot be added into
this VLAN, and vice versa.
4.2.3 Enabling/Disabling POS Port
When the corresponding parameters and protocols are configured, you can use undo
shutdown command to enable the POS port. You also can use undo shutdown to
disable it if you want to stop data forwarding at it.
Perform the following configuration in POS port view.
Table 4-3 Enabling/Disabling POS port
Enable POS port
Disable POS port
By default, POS port is enabled.
4.2.4 Configuring POS Port Description
Perform the following configuration in POS port view.
Operation
Operation
Operation
4-2
Chapter 4 POS Port Configuration
Command
interface pos interface-number
Command
pos access vlan vlan-id
undo pos access vlan
Command
shutdown
undo shutdown