H3C S9500 Series Operation Manual page 231

Operation Manual – Routing Protocol
H3C S9500 Series Routing Switches
If the link, which does not support broadcast or multicast packets, runs RIP, you need to
configure RIP to send any packet to the specified destination, establishing RIP
neighbors correctly.
In NBMA link networking through a Frame Relay sub-interface and others, to ensure
the routing information can be correctly transmitted, you possibly need to disable split
horizon.
2) RIP route management
You can make the following configurations for RIP to advertise and receive routing
information:
Setting additional routing metric
Configuring RIP to import routers of other protocols
Configuring RIP route filtering
Enabling/disabling host route receiving by the router
Configuring RIP-2 route summary
3) RIP configuration
Configuring the RIP precedence
Configuring RIP timers
Configuring zero field check for RIP-1 packets
Specifying RIP version of the interface
4) Configuration related to security
You can select the following configurations to improve RIP security during exchanging
routing information, or control the area to transmit RIP packets.
Setting RIP-2 packet authentication
Specifying the operating state of the interface
3.2.1 Enabling RIP and Entering RIP View
Perform the following configurations in system view.
Table 3-1 Enable RIP and enter RIP view
Enable RIP and enter the RIP view
Disable RIP
By default, RIP is not enabled.
3.2.2 Enabling RIP on the Specified Network Segment
To flexibly control RIP operation, you can enable RIP on the specified network segment
so that the corresponding ports can receive and send RIP packets.
Operation
3-3
Chapter 3 RIP Configuration
Command
rip
undo rip