Configuring The Pim-Sm Domain Border; Configuring The Filtering Of Multicast Source/Group; Configuring The Filtering Of Pim Neighbor; Configuring Rp To Filter The Register Messages Sent By Dr - H3C S9500 Series Operation Manual

Operation Manual – Multicast Protocol
H3C S9500 Series Routing Switches
Caution:
When the RP elected by BSR mechanism is effective, static RP does not work.
All routers in the PIM domain must be configured with this command simultaneously,
with the same RP address specified.
The system supports up to ten different static RP addresses. When more than ten
static RP addresses are configured, the system will give this prompt information:
"Cannot config static-rp, exceeded static-rp limit 10".

7.2.8 Configuring the PIM-SM Domain Border

After the PIM-SM domain border is configured, bootstrap messages can not cross the
border in any direction. In this way, the PIM-SM domain can be split.
Perform the following configuration in VLAN interface view.
Table 7-5 Configuring the PIM-SM domain border
Set the PIM-SM domain border
Remove the PIM-SM domain border configured
By default, no domain border is set.
After this configuration is performed, a bootstrap message can not cross the border but
other PIM packets can. This configuration can effectively divide a network into domains
using different BSRs.

7.2.9 Configuring the filtering of multicast source/group

Refer to 6.2.5 Configuring the Filtering of Multicast Source/Group.

7.2.10 Configuring the filtering of PIM neighbor

Refer to 6.2.6 Configuring the Filtering of PIM Neighbor.
Refer to 6.2.7 Configuring the Maximum Number of PIM Neighbor on an Interface.

7.2.11 Configuring RP to Filter the Register Messages Sent by DR

In the PIM-SM network, the register message filtering mechanism can control which
sources to send messages to which groups on the RP, i.e., RP can filter the register
messages sent by DR to accept specified messages only.
Perform the following configuration in PIM view.
Operation
7-7
Chapter 7 PIM-SM Configuration
Command
pim bsr-boundary
undo pim bsr-boundary