Displaying And Debugging Hgmp Server; Hgmp V1 Configuration Example - H3C S9500 Series Operation Manual

Operation Manual – Integrated Management
H3C S9500 Series Routing Switches

1.2.6 Displaying and Debugging HGMP Server

After performing the above configurations, you can check the information about HGMP
Server by executing the display command in any view to verify these configurations.
You can also debug HGMP Server module by using the debugging command in user
view.
Table 1-14 Display and debug HGMP Server
Display information about the HGMP server
Display operating information about HGMP
Enable/Disable debugging for HGMP

1.3 HGMP V1 Configuration Example

I. Network requirements
Switch A serves as the management device. Switch B and Switch C are connected to
the Ethernet1/1/1 port and Ethernet1/1/2 port of Switch A.
II. Network diagram
B B
Switch Switch
Figure 1-2 Network diagram for HGMP group management
III. Configuration procedure
# Enable HGMP Client on Switch B (refer to the command manual and operation
manual of Switch B for detailed instructions).
The following is only an example. The actual configuration varies with switch model and
the network circumstances.
# Enable HGMP Server on Switch A.
Operation
Device for management Device for management
Switch Switch
1-12
Chapter 1 HGMP V1 Configuration
display hgmpserver
display current-configuration
[ undo ] debugging hgmps { all |
error | info | packet }
A A
C C
Switch Switch
Command