Chapter 3 Device Management; Device Management Overview; Device Management Configuration; Rebooting The Ethernet Switch - H3C S9500 Series Operation Manual

Operation Manual – System Management
H3C S9500 Series Routing Switches

Chapter 3 Device management

3.1 Device Management Overview

With the device management function, the Ethernet Switch can display the current
running state and event debugging information about the slots, thereby implementing
the maintenance and management of the state and communication of the physical
devices. In addition, there is a command available for rebooting the system, when
some function failure occurs.

3.2 Device Management Configuration

The main device management tasks are to check the status of the boards, CPU, and
the memory usage of the switch.
The following sections describe the configuration tasks for device management:

Rebooting the Ethernet Switch

Enabling the Timing Reboot Function

Specifying the Bootstrap Programs for the Routing Switch
Upgrading BootROM
Setting Slot Temperature Limit
Updating Service Processing Boards
3.2.1 Rebooting the Ethernet Switch
It would be necessary for users to reboot the Ethernet switch when failure occurs.
Perform the following configuration in user view.
Table 3-1 Reboot Ethernet switch
Root Ethernet switch
3.2.2 Enabling the Timing Reboot Function
After you enable the timing reboot function on the switch, the switch will be rebooted on
the specified time.
Perform the following configuration in user view, and display schedule reboot
command can be performed in any view.
Operation
3-1
Chapter 3 Device management
Command
reboot [ slot slot-no ]