Only For Measuring In Jog Up To Measuring Cycle Release Sw 6.02.16 - Siemens SINUMERIK 840D sl Programming Manual

Start-up (hardware)
10.3 Commissioning measuring cycles for HMI-Advanced PCU50 powerline up to SW 06.03.18
and/or SW 06.04.08
10.3.2.2

Only for measuring in JOG up to measuring cycle release SW 6.02.16

Only for measuring in JOG up to measuring cycles SW 6.02.16
Variant 1
The GUD7.DEF is not active in the NCU. (HMI/Services/Manage data)
• Transfer GUD7.DEF from the subdirectory "define" (supplied on a floppy disk) to the HMI
• Adjust GUD7.DEF (refer to Subsection 9 "Modifying the GUD7 data block").
• Select the DEF module (HMI/Services/Manage data) and press softkey "Activate".
Variant 2
The GUD7.DEF is already active in the NCU. (HMI/Services/Manage data)
• Save data to the archive or floppy disk using "Services", "Data out", folder "NC-active
• Select definition file GUD7.DEF in menu "Services" in directory "Definitions" with the
• Transfer GUD7.DEF from the subdirectory "define" (supplied on a floppy disk) to the HMI
• The DEF module then has to be adjusted (you will find more details in Subsection 9.3.2
• Once the DEF module has been adjusted, select it (HMI/Services/Manage data) and
• Read the data saved at the beginning back in again via "Services", "Data in".
Only when measuring in JOG from measuring cycles SW 6.3 (also from patch measuring cycles SW
6.02.17) with HMI Advanced from SW 6.3
Variant 1
Modules GUD7.DEF and GUD7_MC.DEF are not active in the NCU. (HMI/Services/Manage
data)
• Transfer GUD7.DEF and GUD7_MC.DEF from the subdirectory "define" (supplied as a
• Select the GUD7_MC.DEF module in the area "Services", "Manage data", in the folder
10-6
using "Services", "Data in" from the floppy disk or using V.24.
data", "User data".
arrow keys and unload it by pressing the softkey "Unload".
using "Services", "Data in" from the floppy disk or using V.24.
"Modifying the GUD7 data block").
press softkey "Activate".
floppy disk) to the HMI using "Services", "Data in" from the floppy disk or using V.24.
"Definitions" and press softkey "Load HD → NC". Then select module GUD7.DEF and
press softkey "Activate".
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles