Rejection, Repetition, End Of Measurement; Rejection And Repetition Of Measurements; Terminating The Measurement - Siemens SINUMERIK 840D sl Programming Manual

4.2.7

Rejection, repetition, end of measurement

4.2.7.1

Rejection and repetition of measurements

The last measurement (Px) can be declared invalid any number of times by pressing the
assigned softkey "Px stored"
. The softkey is then deactivated (grayed out).
Pressing "NC start" again repeats this measurement and the "Px stored" softkey is then
reactivated (black text).
Example
Vertical softkeys P1 to P4 - inactive:
4.2.7.2

Terminating the measurement

If all "Px saved" softkeys are active, then a vertical "calculate" softkey is displayed.
When this softkey is pressed, the measuring points are finally confirmed/acknowledged and
the translatory and rotary offset values are calculated. The result is immediately entered into
the pre-selected "zero offset". If this is identical with "ZO when measuring", the offset values
become immediately effective. This means that the measurements have been completed.
For offsets/corrections, that required e.g. a new alignment/orientation of the measuring probe
or the rotary table, the user is provided with a support function to activate the determined ZO
offset in the JOG mode. Once the "Calculate" softkey has been pressed, this is shown and is
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring in JOG
4.2 Workpiece measurement
4-35