Hardware/Software; Hardware Requirements; General Hardware Prerequisites; Measuring Probe Connection - Siemens SINUMERIK 840D sl Programming Manual

Hardware/software

8.1

Hardware requirements

8.1
8.1.1

General hardware prerequisites

Axis assignment
For correct execution of the measuring cycles the machine axes must be assigned according
to DIN 66217.
Probes that can be used
Switching probes should be connected up for the measuring cycles.
For an explanation of these, refer to descriptions in Section 1.6 "Probes that can be used".
8.1.2

Measuring probe connection

8.1.2.1

General information

Only the main situation regarding the connections assigned to the probe signal are shown
below in the cable distributor and on the control units.
8.1.2.2

SINUMERIK 810D, 840D powerline, 840Di

The probe for SINUMERIK 810D, 840D powerline or 840Di is generally connected up via the
additional "cable distributor" module!
The cable distributor is universally connected to the peripheral interface X121.
For more detailed information on contact routing, electric characteristics, and additional
material needed, see:
References:
/PHC/ SINUMERIK 810D HW Configuration Manual
/PHD/ SINUMERIK 840D NCU Configuration Manual
/HBi/ SINUMERIK 840Di Manual
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
8
8-1