Step 2 - Load Cycle Programs - Siemens SINUMERIK 840D sl Programming Manual

10.3 Commissioning measuring cycles for HMI-Advanced PCU50 powerline up to SW 06.03.18
and/or SW 06.04.08
Variant 2.1
The GUD7.DEF is already active in the NCU, the GUD7_MC.DEF is not active.
(HMI/Services/Manage data)
• Save data to the archive or floppy disk using "Services", "Data out", folder "NC-active
• Select definition file GUD7.DEF in menu "Services" in directory "Definitions" with the
• Transfer GUD7.DEF and GUD7_MC.DEF from the subdirectory "define" (supplied as a
• Select the GUD7_MC.DEF module in the area "Services", "Manage data", in the folder
• Read the data saved at the beginning back in again via "Services", "Data in".
Variant 2.2
The GGUD7.DEF and GUD7_MC.DEF are not active in the NCU. (HMI/Services/Manage
data)
• Save data to the archive or floppy disk using "Services", "Data out", folder "NC-active
• Select definition files GUD7.DEF and GUD7_MC.DEF individually in the menu "Services",
• Transfer GUD7.DEF and GUD7_MC.DEF from the subdirectory "define" (supplied as a
• Select the GUD7_MC.DEF module in the area "Services", "Manage data", in the folder
• Read the data saved at the beginning back in again via "Services", "Data in".
10.3.3 Step 2 – load cycle programs
• Read in the cycles from the subdirectory "cycles" (supplied as a floppy disk) from the
• If new cycles are added, load these in the NCU if necessary.
• Run NC reset to update the cycle interface (HMI/Commissioning/NC reset)
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
data", "User data".
arrow keys and unload it by pressing the softkey "Unload".
floppy disk) to the HMI using "Services", "Data in" from the floppy disk or using V.24.
"Definitions" and press softkey "Load HD → NC". Then select module GUD7.DEF and
press softkey "Activate".
data", "User data".
directory "Definitions" and unload by pressing the softkey "Unload".
floppy disk) to the HMI using "Services", "Data in" from the floppy disk or using V.24.
"Definitions" and press softkey "Load HD → NC". Then select module GUD7.DEF and
press softkey "Activate".
floppy disk or using V.24.
The cycles can be read in individually or as a package depending on the technology.
The following packages are available in the software supplied:
- mcycles.spf
- mcycmill.spf
- mcycturn.spf
→ all measuring cycles for milling and turning
→ all measuring cycles for milling technology
→ all measuring cycles for turning technology
Start-up (hardware)
10-7