Complex Example For Tool Measurement - Siemens SINUMERIK 840D sl Programming Manual

Measuring Cycles for Turning Machines

6.7 Complex example for tool measurement

6.7 Complex example for tool measurement
6.7
Exercise
The workpiece shown in the figure is to be measured with workpiece probe 1 with cutting
edge position 7, inserted as tool T8, D1, in CYCLE974.
This tool master is previously calibrated with CYCLE973 in reference groove 1 in both axes
in the negative direction.
Measuring points P1 to P4 were machined with different tools T1 D1 to T4 D1. These tools
are to be automatically corrected in the length (according to measuring axis _MA) without
empirical and mean values.
6-88
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles